![control switch control switch](https://ae01.alicdn.com/kf/HTB1ku.0gWagSKJjy0Fbq6y.mVXa5/AC-220V-1CH-10A-Relay-Wireless-Remote-Control-Switch-Remote-Light-Switch-System-Receiver-Transmitter-Remote.jpg)
![control switch control switch](https://i.ebayimg.com/images/i/400634781759-0-1/s-l1000.jpg)
Quickly release and click the B-button again.Wait for the visual LED indicator to glow violet.Press and hold the B-button to enter the menu.Remove the Switch 2 from the wall switch box.Testing may stress the network, so it is recommended to perform the test only in special cases.įollow the below instructions to test the main controller’s range: To make Z-Wave range test possible, the device must be added to the Z-Wave controller. Close the wall switch box and turn on the mains voltage.Turn off the mains voltage, then arrange the device and its antenna in a wall switch box.After verifying correctness of the connection switch on the mains voltage.Connect with one of the diagrams below for appropriate device.Switch off the mains voltage (disable the fuse).Q2 – output terminal of the 2nd channel (only Double Switch 2)ī – service button (used to add/remove the device and navigate the menu) Q/Q1 – output terminal of the 1st channel S1 – terminal for 1st switch (has the function of activating the learning mode) Length of wires used to connect the control switch should not exceed 10m.Electrical switches used in installation should be compliant with the relevant safety standards,.The Switch 2 should be installed in a wall switch box compliant with a relevant national safety standards and with depth no less than 60mm,.Connect only in accordance with one of the diagrams,.When connecting the device act in accordance with the following rules:
CONTROL SWITCH MANUAL
Connecting the device in a manner inconsistent with manual may cause risk to health, life or material damage.